Censtar sight glass,level sight glass,oil sight glass

Hose Swivel

Sight Glass(three side)

Address: No.4 Xuesong Rd, Hi-New Technology Industry Development Zone, Zhengzhou City, Henan Province, P. R. China,450001
Tel/Whatsapp: 86-13700884564
E-mail: [email protected]

Sight Glass(three side)

oil sight glass

Censtar sight glass tighten the knob of each screw torque should be almost the same, so as to avoid the pump cover and pump body combined with the face seal is lax. 6, before the oil pump will be loaded on the level sight glass separator should be carefully check whether pump pad damage, whether to put back.Oil pump installed, should guarantee the pump pulley the symmetry center of surface and motor pulley center of symmetry in the same plane, the motion of the pulley oil sight glass is not allowed to have obvious and axial beat phenomenon.

Products Configuration

Technical Parameters

Advantages

Options

Comments

A common fault of self-styled oil gun. sight glass oil gun cannot be closed or shut down after a small amount of oil.The reason is that a foreign body between the main valve and valve seat or valve spring failure, not sealing function.The solution is to clean the main valve, spin valve spring or replace vice valve spring. not self-styled oil gun.Reason is untight seal switch thin film on the cavity and the level sight glass outside world, such as plastic cavity pressure wire is not tight, oil gun mouth connecting sleeve and the auxiliary seat in the O type sealing ring is oil sight glass damaged, make the switch membrane could not form pressure difference between inferior vena.

Couple(connected to nozzle)

Couple(connected to hose)

Swivel (made in china)

Sight Glass(Singleside)

Sight Glass(three side)

Sight Glass(three side)

oil sight glass